![]() The bundles are available in the table at Packages that include the VPN configuration file specific to each user and To configure a VPN client is by using the Zentyal bundles. Once you have done this, it is time to configure the clients. If Zentyal server is both the VPN server and the gateway (most common These internal networks will use the Zentyal VPN as gateway, instead of their default gateway. Networks to which you can access from the VPN. Network Address Translation (NAT): It is recommended to enable this translation if the Zentyal server thatĪccepts the VPN connections is not the default gateway of the internal You can also use a TUN type interface, more similar to a TUN interface: By default a TAP type interface is used, more similar to a Bridge With the selected string of characters to authorize the connection. Client authorization by common name: Requires that the Common name of the client certificate will start Unless you want to import an external certificate, Issues a certificate for the server by default, with the name Server certificate: Certificate that will show the server to its clients. Not overlap with any other and for the purposes of firewall, it You must take care that this network does In case more advanced configuration is necessary: VPN address: Indicates the virtual subnet where the VPN server and its clients will be located. In most of the cases, you can leave the rest of the configuration options with their Using their VPN addresses, you must enable the option If you want the VPN clients to be able to connect between themselves by Only two interfaces are required, one internal for LAN and one external Therefore, you must set at least one of your interfaces asĮxternal at Network ‣ Interfaces. The networks connected directly to the network interfaces of the host,Īs you can see, the VPN server will be listening on all external ![]() InĪddition, you will automatically be notified of local networks, i.e. You must make sure that there is no conflict with a local network. If you need to change the Network address, ![]() The VPN network addresses are assigned both (Zentyal will create one automatically using the VPN server name) and The router on network B does its job and sends the request to the correct workstation.The following configuration parameters are added automatically and can beĮdited if necessary: Port/Protocol, Certificate If your network B was 192.168.1.x then the router WILL say "I don't look after 192.168.1.x addresses but (if a route to say that the VPN knows where to find the answer) I will send this over the VPN and see what response I get". ![]() 3 is only on the other network (B) - it will not make a connection and timeout. 2 will either receive a response from the. It is saying "the address is within my LAN so don't route elsewhere (I.e. When a computer in network A (192.168.0.2) tries to talk to, say, 192.168.0.3 the router will think this address is within the local network (A). The reason why you can't (and shouldn't) is due to the fact that a router's job is to route traffic from a known network to an unknown network. Do you mean you are trying to get two LANs of the same subnet to talk via a VPN? You use the term "192.168.0.x" so one would assume you are talking about a range of IPs within the given 192.168.0.x subnet.
0 Comments
Leave a Reply. |